ROC Hobby Swift Pusher Jet - ARTF
We clocked the RocHobby Swift at over 85mph using our Pocket Radar; and that was flying on an older LiPo with high internal resistance. Not only is this plane fast but it also is very well mannered and very aerobatic. The wings and fuselage are a single piece of EPO foam with carbon rods molded in for maximum strength and durability. In addition, the nose cone is a magnetic break away design, the servo pushrods are top mounted for maximum protection during belly landing, and there is a skid plate on the bottom to protect the fuse and the rear mounted propeller. This is by far one of the fastest and most adrenaline pumping planes we have ever flown!
The RocHobby Swift is very simple to assemble so you can be in the air in about 30 minutes. Although this plane is capable of extremely fast speed, it is very well mannered and has no bad habits. Hand launching is a breeze, just set to half throttle and throw into the wind. We think FMS really has a winner in this RocHobby plane.
- EPO foam construction
- Very simple assembly
- Brushless motor, ESC and servos installed
- Wingspan 675mm / 26.8in
- Length 630mm / 25in
- Flying Weight
- Power System 2215-KV3000
- Speed Control 30A, Internal SBEC, deans
- Propeller /4.5 x 4.5E 2 blade prop
- Landing Gear belly lander (skid plate)
- Servos 9g×2
- Rudder No - Deltawing
- Flaps No
- Ailerons Yes
- Lights No
- Foam Material EPO Foam
Please Note: This is sold in ARTF format and requires Radio System (with Elevon mix), 3S Li-Po Battery, Charger and AA batteries.